Publicidad
Idiomas disponibles
Idiomas disponibles
Connect Hose and Water Supply to Pump
NOTE:Removeand discard atl pump shipping caps before
attaching hoses.
1.
Uncoii high pressure hose and attach one end of hose to
base of spray gun. Tighten by hand.
WARNING
The high pressure stream of water that this
_
quipment produces can cut through skin and its
underlying tissues, leading to serious injury and
)ossibteamputation.
* NEVER cormecthigh pressurehoseto nozzle extension.
* Keephigh pressurehoseconnected to purnpand spraygun
whilesystemis pressurized.
. Alwaysbecertainspraygun,nozzles and accessories are
correctlyattached.
2.
Attach other end of high pressure hose to high pressure
outlet on pump. Tighten by hand.
3.
Before connecting garden hose to water inlet, inspect
inlet screen (A). Cleanscreen if it contains debris or
have it replaced if damaged. 00 NOT run pressure
washer if intet screen is damaged.
4.
Run water through garden hose for 30 seconds to flush
it of debris. Turn off water.
iMPORTANT: DO NOTsiphon standing water for the water
supply. Use ONLYcold water (less than 100%).
5.
Connectgarden hose (not to exceed 50 feet in length) to
water inlet. Tighten by hand.
NOTICE
Using a OneWay Valve (vacuum breaker or check valve) at
pump inlet can cause pump or inlet connector damage.
ThereMUSTbe at leastten feet of unrestricted gardenhose
between thepressurewasherinletand anydevice,suchas a
vacuumbreaker o r checkvalve.
Damage to equipment r esultingfrom failureto followthis
6.
Turn ONwater, point gun in a safe direction and squeeze
trigger on spray gun to purge pump system of air and
impurities.
WARNING
>_sRiSk
eye injury.
of
pray can spiash back or propei objects.
Alwayswearsafetygoggles when usingthis equipment o r in
vicinityof whereequipment i s in use.
Beforestartingthe pressurewasher,be sureyouare wearing
adequate safetygoggles.
NEVER substitutesafetyglassesfor safetygoggles.
ChecMist Befere Starting Engine
Reviewthe assembiy to ensure you have performed all of the
following:
1.
Be sure to read Safety Rules and Operationsections
before using the pressure washer.
2.
Make sure handie is in ptace and secure.
3.
Checkthat oil has been added to proper level in engine
crankcase.
4.
Add proper fuei to fuei tank.
5.
Checkfor properly tigiltened hose connections (higll
pressure and water suppty) and for tight connections
and that there are no kinks, cuts, or damageto the high
pressure hose.
6.
Provide proper water supply (not to exceed lOB°F)=
Publicidad
