Angle Trimming; Dust Extraction; Maintenance - Fox F36-523 Manual De Instrucciones

To trim pieces which are equal to or less than 150 mm wide, use the rip fence only on the right side of the blade
and use the pusher to push the piece until it is completely cut.
Connect the dust-collection device to the back output of the
machine.
A suitable extraction device or an external dust collector
can be connected to the machine, in the back side of the
base there is the coupling for the aspiration pipe.
Always connect the table saw to an external dust-collection
device, since the dust of different kinds of wood can be
dangerous for the health of the operator.
We recommend you to always use a dust collector to
remove the dust which has been produced while using the
machine. Besides, it is preferable that you clean accurately
the machine to remove all dust piles at the end of each
work.
WARNING: Before any adjustment, repair or maintenance work, and before changing
the blade, switch off the machine and disconnect it form any current source by
removing the plug from the socket.
In case you find out any damage to the protection devices or irregularities while processing or checking the
machine, you must get it repaired immediately by qualified persons.
Before use check that the protection and safety devices are perfectly efficient. After carrying out the work, make
a general cleaning of the machine by removing dust and chips.
In the event of intensive use of the table saw, the frequency of checks could be:
1. Daily
Vacuum away any sawdust which may have accumulated in the machine and clean the motor ventilation slots.
Make sure the blade guards always slide smoothly.
2. Weekly
Make sure the blade unit up - down movement and tilting from 0° - 45° always run smoothly.
3. Monthly
Check the blade stopping time; should it be higher than 10 seconds, have the saw overhauled by a Service
Center.
Check the noisiness of the motor and consumption of the brushes. (Fig.30)
Check that the power cable is intact.
Check that the play of the gears and if necessary get them changes by an after-sales center.
EN

ANGLE TRIMMING

DUST EXTRACTION

MAINTENANCE

47