Malfunctions; Service - Fox F36-523 Manual De Instrucciones

PROBLEM
The saw does not start:
Machine vibrations:
Wood darkens while cutting:
The tools wear rapidly:
The motor does not work properly:
Blade stops rotating:
The blade rejects the wood:
Other:
All Fox tools and accessories are made and tested by using the safest and most modern productive methods.
However, if a tool get damaged, it must be repaired by an authorized after sales centre.
The list of assistance centres is available at the various sales outlets or by sending a request to
machines.com..
EN

MALFUNCTIONS

POSSIBLE CAUSE
The electric current is missing in the socket to which the supply
cable is connected
The supply cable is faulty
The motor is damaged or the carbon brushes must be replaced
The inclination lock handle is not correctly tightened
The blade is not correctly fixed
The tool is not correctly sharpened
The tool has been assembled back-to-front
The tool is not correctly sharpened
The wood is dirty (cement, sand, etc.)
(excessive heating, exagerated twinkle of the carbon brushes
and consequent noise accentuation)
The motor may be damaged: get the machine checked by an
electrician
Carbon brushes must be replaced
Overload (the speed is too high, the tool is not sharpened)
The rip fence is not parallel
The riving knife is not aligned correctly
The bearings make noise: get them changed
Check that the play of the gears and if necessary get them
changes by an after-sales center.

SERVICE

50
info@fox-