Proxxon GG 12 Manual página 4

Translation of the Original Operating
GB
Instructions PROXXON GG 12 Set
Dear Customer,
Please read these safety regulations and operating instruc-
tions before using the tool.
WARNING!
Read all safety warnings and instructions. Failure to
follow all safety warnings and instructions listed
below may result in electric shock, fire and/or serious
injury.
KEEP ALL SAFETY WARNINGS AND INSTRUCTIONS FOR
THE FUTURE!
Read the operating instructions!
Wear eye protection!
Protection class II device
Use only in dry rooms
The sound intensity level for the operator
can exceed 80 db(A) in some
circumstances. Please wear
hearing protection!
Isolation transformer
Description of the machine
Engraving glass, acrylic and ceramic (and also steel) is an
enjoyable hobby. Congratulations on purchasing the appro-
priate tool for this hobby. This is a precision tool that will make
this pastime a particular pleasure. You will be satisfied with the
result of your work after just a little practice.
Scope of delivery
1 engraving tool GG 12
1 voltage supply unit, model SNG
1 ball-shaped abrasive diamond pencil 1.0 mm
1 ball-shaped abrasive diamond pencil 1.8 mm
1 conical silicon-carbide abrasive pencil
1 bullet-shaped silicon-carbide abrasive pencil
1 piece of glass for experimenting
1 robust case
- 4 -
Technical features:
Technical data
Device:
Length:
Weight:
Voltage:
Rotational speed:
Noise level:
General measuring uncertainty
Vibration:
General measuring uncertainty
Charger:
Mains voltage:
Output voltage:
Charging current:
Noise/vibration information
The information on vibration and noise emission has been
determined in compliance with the prescribed standardised
and normative measuring methods and can be used to com-
pare electrical devices and tools with each other.
These values also allow a preliminary evaluation of the loads
caused by vibration and noise emissions.
Depending on the operating conditions, the emissions that
actually occur may deviate from the values given above!
This applies in particular depending on the workpiece to be
machined and the insert tool (especially its wear condition).
Unsuitable workpieces or materials, poorly maintained tools,
too high a feed rate or unsuitable insert tools can significantly
increase the vibration load and noise generation.
To more accurately estimate the actual vibration and noise
load, also take the times into consideration where the device
is switched off, or is running but is not actually in use. This can
clearly reduce the vibration and noise load across the entire
work period.
Immediately interrupt the operation of the tool if excessive
vibration occurs for the reasons mentioned above.
approx. 150 mm
approx. 60 g
12-18 V
20000/min
< 70 dB(A)
K=3 dB
2,5 m/ s 2
K=1,5 m/s 2
230 V~, 50/60 Hz
12.6 V
500 mA
Warning!