Proxxon GG 12 Manual página 5

Commissioning
Only use inserting tools with a 2.35-mm shaft. Clamp shaft
with pliers and insert into the mount to the stop ( Fig. 1 ).
Fig. 1
Never overload the tool by pressing too hard. Always remem-
ber that power is provided by the rotational speed and not the
contact pressure.
Only operate the GG 12 with the voltage supply unit provi ded
or other PROXXON voltage supply units (NG 2/S/E or
NG 5/E).
Working with the tool:
Switch on the tool and hold like a pen with a gentle grip. Rest
the lower half of your arm on the table or against your body.
After some practice, we recommend that you work with tem-
plates (available in shops). Simply adhere these to the rear of
the glass with adhesive tape. Always make the outline first.
Use the diamond abrasive pencils to do this. Then create matt
surfaces with the silicon-carbide pencils.
Always remember:
Practice makes perfect. At the beginning, use simple types of
glass (panes or cylindrical glass). Use dark materials under-
neath to give a better contrast.
Care and maintenance
Except for occasional cleaning, no special maintenance is
required for your engraving tool. If you follow the instructions
in this User Manual, the tool will reliably and safely provide
you with valuable services for many years.
Disposal:
Please do not dispose of the device in domestic waste! The
device contains valuable substances that can be recycled. If
you have any questions about this, please contact your local
waste management enterprise or other corresponding munic-
ipal facilities.
Note:
EC declaration of conformity
Name and address
of the manufacturer:
Product designation:
Article No.:
In sole responsibility, we declare that this product conforms to
the following directives and normative documents:
EU EMC Directive
EU Machinery Directive
Date:
Dipl.-Ing. Jörg Wagner
PROXXON S.A.
Machine Safety Department
The CE document authorized agent is identical with the signatory.
PROXXON S.A.
6-10, Härebierg
L-6868 Wecker
GG 12 Set
28635
2014/30/EU
EN 55014-1:2017
EN 55014-2:2015
EN 61000-3-2:2014
EN 61000-3-3:2013
2006/42/EC
EN 62841-1:2015
14.09.2021
- 5 -