Publicidad
Idiomas disponibles
Idiomas disponibles
6. Lowerseat into operatingpositionand
sit in seat.
7. Slide seat untila comfortableposition
is reachedwhich allowsyou to press
clutch/brakepedal all the way down,
8, Get off seat withoutmovingits
ad-
justed
position.
9.
Raise seat and tighten adjustment
knob securely.
Seat
Bolt
Flat Washer
\.
Adjost /oo(Knob
CHECK
BATTERY
1_ Lift seat pan to raised position.
NOTE:
If this battery
is put into service
after month and year indicated
on label
(label located
between
terminals)
charge
battery
for minimum
of one hour at 6-10
amps. (See "BATTERY"
in Maintenance
section
of this manual
for charging
instruc-
tions).
Seat
Label
Term
Terminal
NOTE:
You may now roll or drive your
tractor
off the skid. Follow the appropriate
instruction
below to remove the tractor
from the skid.
WARNING:
Before starting,
read, un-
derstand
and follow all instructions
in the
Operation
section
of this manual.
Be sure
tractor
is in a well-ventilated
area, Be sure
the area in front of tractor
is clear of other
people
and objects.
TO ROLL
TRACTOR
OFF
SKID
(See
Operation
section
for
location
and
function
of controls)
1. Press lift lever plunger
and raise
attachment
lift lever to its highest
po-
sition.
2o Release
parking
brake by depressing
clutch/brake
pedal.
3.
Place gearshift
lever in neutral
(N)
position.
4,
Roll tractor
forward
off skid.
5.
Remove
banding
holding
the deflector
shield
up against
tractor,
TO DRIVE
TRACTOR
OFF
SKID
(See
Operation
section
for location
and function
of controls)
1o Be sure all the above assembly
steps
have been completed.
2. Check
engine oil level and fill fuel tank
with gasoline.
3. Sit on seat in operating
position,
depress
clutch/brake
pedal and set the
parking
brake.
4.
Place gear shift lever in neutral
(N)
position.
5.
Press lift lever plunger and raise
attachment
lift lever to its highest
posi-
tion.
6.
Remove
key from bag and start the
engine
(see "TO START ENGINE"
in
the Operation
section
of this manual),
After engine
has started,
move throttle
control
to idle (slow) position.
7.
Depress
clutch/brake
pedal into full
"BRAKE"
position and holdo Move
gearshift
lever to 1st gear,
8.
Slowly
release
clutch/brake
pedal and
slowly
drive tractor
off skid.
9.
Apply brake to stop tractor, set park-
ing brake and place gearshift
lever in
neutral
position.
1&Turn
ignition
key to "STOP" position.
Continue
with the instructions
that follow.
9
Publicidad
