Goldanalytix MAGNETICSCREENSCALE Manual De Instrucciones página 28

5 Starting and Operating the Device
Preparing the device:
Place the scale on a stable and level
surface. Level the scale by using the feet
and the spirit level, which are located in
the base of the scale. Turn the feet of the
scale until the air bubble is in the centre.
IMPORTANT:
magnetic scale until it has been fully
installed following the steps below.
Place the scale attachment on the scale
and then carefully screw the magnetic
measuring head into the thread. Do not
apply any pressure; just make sure that the
magnet is fully and firmly in place.
Place the Plexiglas cover on the scale. The
magnetic measuring head and the Plexiglas
cover must not be in contact after the
positioning.
measurement that there is a small distance
between the magnetic measuring head and
the Plexiglas. If there is any contact, the
magnet may not have been screwed onto
the scale correctly.
26
Procedure
Do not switch on the
It is essential for the
Illustration