Publicidad
Idiomas disponibles
Idiomas disponibles
EN
7. Mount the detergent container, then insert the hose with the mesh filter into the container and
tighten the cap clockwise. Connect the hose to the washing liquid hose inlet socket. Check wheth-
er it has been properly installed (Fig. 7).
8. Connect the aluminium tube with the suction hose holder, and then connect the washing liquid
supply hose correctly (Fig. 8).
9. Connect the two aluminium tubes, as shown here (Fig. 9).
10. Connect the washing attachment to the aluminium tube and connect the liquid supply hose to the
socket (Fig. 10).
BATTERY INSTALLATION AND REPLACEMENT IN THE REMOTE CONTROL PANEL
1. The battery cover can be opened by pressing the fastening on the front of the battery compart-
ment with a screwdriver (Fig. 1).
2. Remove the old batteries from the remote control panel (Fig. 2).
3. Replace with a new 23A 12V alkaline battery, paying attention to the proper polarity of anode and
cathode during mounting (Fig. 3).
4. Mount the remote control panel cover (Fig. 4).
CAUTION! The remote control panel can only be used with a 23A 12V alkaline battery. Do not
use batteries with different parameters to avoid damaging the module. The battery constitutes
an integral part of the MOD-48 washing vacuum cleaner set.
PAIRING THE CONTROL PANEL WITH THE VACUUM CLEANER
1. Ensure the connection between the plug and the power source.
2. Press the power switch, the indicator light on the top cover panel will illuminate (Fig. 2).
3. Press the suction button and the washing liquid feed button located on the top cover panel simul-
taneously, the indicator light will turn off (Fig. 3).
4. Press one of the buttons on the control panel handle - the suction button or the detergent feed
button. The indicator light on the top cover panel will flash once and return to normal, indicating
the completion of the panel pairing (Fig. 4).
38
Publicidad
