Publicidad
Idiomas disponibles
Idiomas disponibles
EN
12. Press the suction button on the top cover panel or control panel handle, the unit will start oper-
ating. The suction mode works in two ways: high and low; when working in high mode, press the
suction button and vacuuming switching to low mode, press the button again and the suction will
stop working (Fig. 12).
WET VACUUMING
1. Ensure the power cord is disconnected from the power source (Fig. 1).
2. Place the sponge filter on the float chamber, ensuring that it completely covers the entire float
chamber (Fig. 2).
3. Place the top cover on the container and lock using with clamps situated on both sides (Fig. 3).
4. Mount the selected accessories on the aluminium tube (Fig. 4).
5. Plug in the power cable (Fig. 5).
6. Press the power switch, the indicator light on the top cover panel will illuminate (Fig. 6).
7. Press the suction button on the top cover panel or on the control panel in the handle, the device
will start working. The suction mode operates in two modes: high and low. When working in high
mode, pressing the suction switch results with vacuum switching to low mode, by pressing the
button again and the vacuum cleaner stops working. (Fig. 6-7).
8. When the water absorbed reaches maximum capacity, the safety valve will trigger and the dust;
the floor and carpet head, along with the aluminium pipe, will stop sucking liquids (Fig. 8).
9. Turn off the power and disconnect the power cord from the socket (Fig. 9).
10. Pour out the dirty water and wash the tank thoroughly (Fig. 10).
11. To ensure the best wet vacuuming performance, remove the sponge filter after its use (Fig. 11).
40
Publicidad
