Publicidad
Idiomas disponibles
Idiomas disponibles
Parameters Technicians:
Tool necessary:
4
0.05MHz
8.2
±
24 Vcc
200 mA
8.2 ± 0.05MHz
ll0VCA
SµV
30VA
24 Vcc
24 Vcc
180 mA
Cortadora de disco para concreto
Taladro Eléctrico (cpl0-12)
Taladro electrónico
Llave para ajuste
Martillo
Pinzas de Corte
Pinzas de punta
Destornilladores
Phillips
Destornilladores para ajustes
Flexometro
The middle atmosphere
1.-The selection of the place of mounting.
The antennas must be installed in the entries of the sites. Should not
be near of walls, the distance maximum of closeness is of 0.5m. Must
take in Be aware that equipment generates electrical interference:
welding machines, generating equipment electrical energy, motors,
etc. they can avoid he correct functioning of the RF system.
2
.
-Requires the line of feeding
.
A line 110 Vac for source feeding duly identified phase and neutral
with derivation to land physical. Connecting should be avoided on the
same voltage line to all electrical and electronic equipment.
PROCESS OF FACILITY
The detectors EAS are formed from a transmitting antenna and an
antenna receiver (light red on top and integrated buzzer). Each pair of
antennas contains a fountain of feeding.
Separation of the antennas:
Has to Have on realize that the tags soft or rigid they have different level
of detection and that to his time it varies of agreement to the location of
the same on the product or on the location of the same product by the
user. The distance of separation can vary from 0.9 to 1.2m maximum, it
is very important to calibrate before carrying out any definitive
installation.
Evidence previous to the facility:
After of confirm location of the facility and of the detector distance of
electronic security, you must carry out security tests fit with passing the
relevant tags. To do this you must remove the plastic casings by
removing the screws and with To do this, make the pertinent
connections and adjustments:
Note: You must check with support of Multimeter.
5
Publicidad
