Publicidad
Idiomas disponibles
Idiomas disponibles
CONNECTIONS
a)
The connection between the power supply and the transmitting
antenna.
Fountain of feeding of the wire of power (line red) that connect the
transmitting antenna board "P1" "24V/DC IN" input "+" pole;
Fountain of feeding of the wire of power (line blue), the connection of the
plate the transmitting antenna P1 "24V/DC IN" of input "-" pole
b)
Connection between the transmitting antennas and the receiving antenna
the tablet of the antenna transmitter locate the terminal P6 "24V/DC OUT"
exit of the "+" pole and "-" pole connect it with the antenna recipient on
terminal P1-2 "24V/DC IN", in order to share the power.
Synchronization
When the width of the doors exceeds the scope initial of the antennas, it is
possible to place a transmitting antenna accompanied by two receivers at a
maximum distance of 2m.
8
CONNECTIONS
Connection in Series
First validate that a TX antenna this as Master antenna and that another
antenna this as Slave TX
.
Perform the connection of P3 or P4 (port output)
the tablet major of the transmitter toward the input port P2 of the card
second transmitter. Has to be kept in account: the P3 either P4 of each
antenna board transmission (signal output), can only be connected to a P2
(output port) entrance) of the tablet of auxiliary transmitter. The number of
antennas of TX connected in series cannot exceed more than eight.
9
Publicidad
