Publicidad
Idiomas disponibles
Idiomas disponibles
The worth by flaw of the card of the transmitter are the following:
Tarjeta Principal (Transmisor)
Tarjeta Principal (Auxiliar Exclavo)
Settings for the card major of the receiver. The factory settings are:
1 & 2
2 & 3
Revision of the Operation
You should review the operation of the antennas to confirm the connection, for turn
on the power.
When feed the antennas must observe three blinks of light green of the RX board,
which indicates that he EAS system It is working correctly
the left) yes only has one either two blinks of the light green, or Yeah Green LED
does not light up or only D51 flashes.
1.-The LEDs green (DS 1,DS 2,DS3) serve for indicate Yeah exists some interference
in he atmosphere
.
When he D51 is flashing,D 52,D53 No is on, it indicates that exists
some interference. Yeah D51 is always on, there is serious interference, regardless of
D 52, D 53.
2.-VR4 adjustment, increase the sensitivity by sense of the clock hands. The results
of the detection improve Yeah D 51,D 52 and D53 this always without flash.*In labels
soft: the system must be able of respond with speed to give a acoustic alarm and
visual to the detect it, you can adjust the sensitivity "VR4"(on the right) for lower
sensitivity.
10
Colocar el DIP Switch "Master"
Colocar el DIP Switch "SIave"
Jp1
Jp2
.
Adjustment VR4 (towards
Settings of distances short
To avoid interference in the same installation location with two EAS antenna
assemblies, or to reduce the false alarms it is necessary to perform the
following procedure.
In principle it is important to change the frequency from 180MHz to
170MHz or 160MHz , the procedure is he following:
DIP Switch
1
2
Off
Off
Modulación de
Indicators of Interference LED 3,LED 4(RX):
150
Frecuencia (Hz
)
1)When the interference is small or when there is no interference, LED3 and
LED 4 of RX no they flash.
2)
When there is a strong interference LED3 and LED4 They will be
illuminated
.
He glow on LED4(flashing red) depends of the interference
power.
3)
When the interference is very strong ( for example, high voltage power
supply)LED4(1red light)will be always on,LED3(1green light)will be on or
flashing, in this case you can confirm that there is interference very
serious
.
When he system of RF No generate alarms when detect HE must shorten
distance detection for solve this problem
1
2
1
2
1
Off
On
On
On
Off
160
170
180
.
2
On
Publicidad
