PLAYA - USE AND MAINTENANCE
10. BOTTOM CLEANING
Your mini-pool PLAYA is equipped with a bottom cleaning system that
consists of:
2 rigid pipes
1 brush
1 hose
1 suction plate
The mud-suction broom is
composed connecting the
brush with rigid pipes and
the flexible tube. Place the
pad on top of the skimmer.
Place the free end of the flexible
hose in front of the discharge nozzle of
the system in order to squeeze out all the air
inside of it.
Insert the end of the flexible hose filled with water into
the hole on the plate taking care to lift as little as possible.
Once the mud-suction broom is triggered, it should be used as a normal vacuum
cleaner. It is advisable to move slowly on the bottom in order to prevent dirt from
rising until it has been properly aspirated.
After cleaning the bottom, switch off the pump and disconnect the mud-suction
broom from the skimmer. Before to turn on the pump verify whether it is necessary
to clean the filter, as indicated in section 9 of this manual.
11. WINTER CLOSURE
The setup of the mini-pool PLAYA for the winter closure (prolonged period of non-
use) provides the full emptying of the tank and hence the compliance with the
steps shown below:
1) APPLICATION SECURITY
Remove electric current to the mini-pool PLAYA before passing to the following
points.
2) EMPTYING THE POOL
Proceed with the emptying of PLAYA. In the case of HEATER AND BUBBLES version,
also proceed with the emptying of the hollow chamber and the air cushion.
56