Ego Power+ HTX5300-P Manual página 8

EN
Solid green
Flashing green
Solid red
Battery-status
Flashing red
indicator
Solid orange
Flashing red/
green alternately
Solid green
Speed indicator
(the illustrates
Solid orange
show the high
speed)
Flashing orange
Battery High-temperature Protection
If the battery temperature exceeds 70°C during operation,
the temperature-protection circuit will immediately
shut off the machine to protect the battery pack from
overheating damage. The battery-status indicator will
glow solid orange. Release either of the triggers and wait
until the overheated battery cools down and the indicator
turns green, then restart the machine.
Battery Electronics Error Protection
When the battery pack electronics error occurs, the
battery-status indictor will flash red/green alternately
and the machine will shut off in 3 seconds. Replace the
battery pack or contact EGO customer service center.
8
56 VOLT LITHIUM-ION ACCUHEGGENSCHAAR — HTX5300-P
Indicator Lights Meaning
Battery charge level of 20% to 100%
Battery charge level of 10% to 20%
Battery charge level of less than 10%
The battery pack is nearly depleted and needs
to be charged immediately.
The battery pack is overheated. Cool the battery
pack until the temperature drops below 67°C.
See " Battery High-temperature Protection
" below
The battery pack electronics error. Replace
the battery pack or contact EGO customer
service center. See " Battery Electronics Error
Protection " below.
The machine is working properly.
The machine is overheated. Cool the machine
until the temperature drops below 80°C. See
" Machine High-temperature Protection "
below.
The machine is overloaded. See "Machine
Overload Protection" below.
Machine Overload Protection
This machine features a built-in overload circuit
protection. When the machine is overloaded, the motor
will stop and the speed indicator will flash orange.
Remove the battery pack from the machine, then reattach
the battery pack and restart the machine. Decrease the
load on the machine, avoid cutting too much at a time or
oversize cutting thickness or cutting on the heavy/woody
shrubs.
Machine High-temperature Protection
If the machine temperature exceeds 90°C during
operation, the temperature-protection circuit will
immediately shut off the machine to prevent overheating
damage. The speed indicator will glow solid orange.