Ego Power+ HTX5300-P Manual página 9

Release the trigger and wait until the overheated machine
cools down and the speed indicator turns green, then
restart the machine.
BLUETOOTH WIRELESS TECHNOLOGY
®
Products with built-in Bluetooth
®
connect to EGO Connect services via your mobile device
or EGO Bluetooth ® Gateway device. For information or our
full range of connected products and services, including
connection instructions, please scan QR Code below or
visit www.egopowerplus.eu/connect.
The Bluetooth symbol will light up when machine is
®
connected.
USING THE HEDGE TRIMMER
DANGER:
If the blade jams on any electrical cord
or line, DO NOT TOUCH THE BLADES! IT CAN BECOME
ELECTRICALLY LIVE AND VERY DANGEROUS. Continue
to hold the hedge trimmer by the insulated rear handle
or lay it down and away from you in a safe manner.
Disconnect the electrical service to the damaged line or
cord before attempting to free the blades from the line
or cord. Failure to heed this warning will result in serious
personal injury or possible death.
WARNING:
If any parts are missing, damaged or
broken, do not operate your trimmer until they have been
replaced. Failure to do so could result in possibly serious
personal injury.
WARNING:
To prevent serious personal injury,
always use both the front handle and the rear handle to
hold the hedge trimmer during operation.
WARNING:
To prevent serious personal injury,
keep hands away from blades. Do not attempt to remove
cut material or hold material to be cut when the blades
are moving. Make sure that the blades have completely
stopped and the battery pack is removed before clearing
jammed material from blades. Do not grasp the exposed
cutting blades or cutting edges when picking up or
holding the unit.
WARNING:
Clear the area to be cut before each use.
Remove all objects, such as cords, lights, wire, or string
which can become entangled in the cutting blade and
create a risk of serious personal injury.
◾
Before starting the hedge trimmer, maintain proper
footing and balance and do not overreach. Do not
operate the trimmer in a tree, on a ladder, from a
rooftop, or any unstable support. Wear safety goggles,
non-skid footwear and rubber gloves. Hold the unit
with both hands, with the cutting blade directed away
wireless technology can
from you.
◾
Do not trim too much at a time. This can cause the
blades to bind and slow down, reducing the cutting
efficiency.
◾
Do not force the hedge trimmer through heavy
shrubbery. This can cause the blades to bind and slow
down. If the blades slow down, reduce the pace of
your work.
◾
When trimming new growth, use a wide sweeping
action, so that the stems are fed directly into the
cutting blade. Older growth will have thicker stems and
will be trimmed most easily by using a back-and-forth
motion.
◾
Always cut stems or twigs that are less than 28 mm
thick. Use a non-powered hand saw or pruning saw to
trim large stems.
Top Cutting (Fig. G)
Use a wide sweeping motion. A slight downward tilt of the
cutting blades in the direction of motion gives the best
cutting results. For a better cutting effect, you may use
the string to guide the hedge level.
Side Cutting (Fig. H)
When trimming the sides of the hedge, begin at the
bottom and cut upwards. Trim the side of a hedge so
that it will be slightly narrower at the top. This shape will
expose more of the hedge to sunlight, resulting in a more
uniform growth.
Tip Protector (Fig. J)
The tip protector is used to protect the outer end of the
blade.
Blade Guard (Fig. K)
The outer part of the blades is shaped as blade guards.
damaged or distorted. Replace it if it is bent or damaged.
56 VOLT LITHIUM-ION ACCUHEGGENSCHAAR —— HTX5300-P
WARNING:
Always check that the blade guard is not
EN
9