Descargar Imprimir esta página

Panasonic EYADA Serie Manual De Instrucciones página 8

Ocultar thumbs Ver también para EYADA Serie:

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

RUNNING MODE
This tool runs in one of the modes below.
The current mode is shown by the communication lamp and in the display on the
control panel.
To enable all functions, pair the tool with the controller and use it in the "Wireless
Communication Mode".
To switch the running mode, refer to " b9 Running Mode Switching Setting".
Communication lamp
Display
Stand Alone Mode * Initial setting
The tool is not connected to the controller in this mode.
Communication
Display
lamp
Off
Pairing Mode
The tool is ready to connect to the controller in this mode.
Communication
lamp
Blinking rapidly
Pairing is in progress.
(0.2 s cycle)
Pairing has been completed and the tool is connected to the
Solid on
controller.
Blinking slowly
The tool is retrying to connect and waiting for a wireless signal.
(1 s cycle)
14
EN
Details
Allows screw fastening with clutch.
The history is not saved.
P. 28
Details
Wireless Communication Mode
The tool is connected to the controller in this mode.
Communication
lamp
P. 55
Solid on
Solid on
Solid on
Solid on
Solid on
Display
Details
Operation is prohibited.
(in the sequence mode without parameters set)
In this state, the tool does not start operation.
* Refer to "SETTING THE FASTENING
CONTROL MODE" in the Operating Instructions
of the controller (EYARW1).
Counting is in progress.
The number of remaining screws to be fastened
or the number of fastened screws is shown on
the display.
The unit is running in the Free mode that does
not manage the quantity to fasten.
An overcurrent warning, component failure, or
out-of-wireless coverage warning occurred.
A code of E with a number is shown in the
display.
P. 60
The tool stopped without clutch activated or did
not satisfy the fastening quality judgement
conditions.
A code of F with a number is shown in the
display.
P. 63
15
EN

Publicidad

loading

Este manual también es adecuado para:

Eyada212waEyada218waEyada407waEyada212wbEyada218wbEyada407wb