Cleaning & Maintenance - Kitchen Living RJ30-ALDI Manual Del Usuario

Single Cup Brewing System
Cleaning & Maintenance
Regular cleaning of the Brewer's external components is recommended.
1. Never immerse the Brewer in water or other liquids. The housing and other
external components may be cleaned with a soapy, damp, non-abrasive
cloth.
and Drip Tray Plate should be periodically inspected and rinsed clean.
REMOVING THE DRIP TRAY ASSEMBLY
Slightly lift tray while keeping it leveled at all times to avoid
spilling. The Drip Tray and Drip Tray Plate may be placed
in the dishwasher. They may also be cleaned with a damp,
soapy, non-abrasive cloth and rinsed thoroughly.
CLEANING THE CARTRIDGE
The cartridge can be placed onto the top shelf of a
dishwasher.
NOTE: Use low temperature cycles in the dishwasher.
To remove from the Brewer, open the Brewer Head by
lifting the Latch. Grasp the top of the cartridge with one
hand, pull upward until it releases. After cleaning, simply
insert the cartridge back into the compartment, be sure the
CLEANING THE EXIT NEEDLE
The exit needle is located on the inside bottom of the
cartridge. Should a clog arise due to coffee grinds, it can
be cleaned using a paper clip or similar tool. Remove
cartridge, insert the paper clip (as shown left) into the
needle to loosen the clog and push it out.
CAUTION: There are sharp needles that puncture the
portion pack above the cartridge and in the bottom of the cartridge. To avoid
CLEANING THE SPOUT
Should a clog arise due to coffee grinds, it can be cleaned using a paper clip
or similar tool. Remove cartridge, insert the paper clip into the Spout to loosen
the clog and push it out.
AFTER SALES SUPPORT
888-315-8407
USA
Cleaning & Maintenance
customerwarranty@rjbrands.com
MODEL: RJ30-ALDI PRODUCT CODE: 47047 12/14
USA
11