GINGKO LunaSpin Manual De Instrucciones página 5

Product Operation by Touch Mode
You can change the setting by tapping the round magnet charging dot
located at the bottom of the Smart LunaSpin Lamp.
Quick Tap 1 time on the button to change the light setting between White,
Warm Yellow, Cool White or OFF
Long Tap to adjust the brightness of the lamp, remove finger when you have
reach your desired brightness. Please note the light will be re-set to original
brightness when it's turned off, you will have to re-adjust the brightness when
you turn the lamp on again.
A Quick Tap 2 times to activate or deactivate the spin function.
Quick Tap 3 time to activate TAP Mode. The light will flash once when the
mode has been activated or deactivate.
You can place the lamp on any hard, flat surfaces. PLEASE NOTE: The light
colour might change when you place the lamp on any other surface due
to vibration, you can change back to your desired light colour using the
remote provided or tap mode.