Publicidad
Idiomas disponibles
Idiomas disponibles
Resetting the unit ~
Cc
Reset button
Note
1 Press (OFF).
2 Press
to open up the front
panel, and detach the panel by pulling it
towards you.
Notes
© Be sure not to drop the panel when detaching it from the
unit,
© If you press
to detach the panel while the
unit és still turned on, the power will automatically turn
off to protect the speakers from being damaged.
Attaching the front panel
Attach part @ of the front panel to part ® of
the unit as illustrated and push until it clicks.
Notes
¢ Make sure the front panel is the right way up when
attaching it to the unit as it caunot be attached upside
down.
¢ Do not press the front panel hard against the unit when
attaching it to the unit. It can easily be attached by
pressing it lightly against the unit.
¢ When you carry the front panel with you, put it in the
supplied front panel case.
© Do not press hard or give excessive pressure to the
display windows of the front i.
¢ Do uit expose the front panel to direct suntight, heat
sources such as hot air ducts or leave it ina humid place.
Never leave it on the dashboard etc. of a car parked in
direct sunlight where there may be a considerable rise in
temperature inside the car.
Caution alarm
If you turn the ignition key to the OFF position
without removing the front panel, the caution
alarm will beep for a few seconds (only when
the POWER SELECT switch is set to the ®
position).
If you connect an optional power amplifier
and do not use the Built-in amplifier, the beep
tone will be disabled.
Preparing the rotary
remote
When you mount the rotary remote, attach the
label in the illustration below.
XR-C5SORDS:
Publicidad
