avide CLAUDE ABLDL-BLC Manual Del Usuario página 3

Before using the product for the first time, please read the instructions and retain them for later reference.
Warnings:
Make sure that the appliance has not damaged during transport. Do not dissamble the product at home. To avoid
demages, please do not overtighten the adjustable parts of the lamp. Please do not use the lamp at high temperatures
or in high humidity environments. The lamp can only be used in dry, indoor conditions! Do not stare into the light of
the LED.
In the following cases, please unplug the power cord immediatley and do not use the lamp:
The power cord or the connector has been damaged. If the power cable becomes damaged, it should be replaced with
cables, obtained directly from the manufacturer or its service facility. The lamp base is humid or wet. In case of any
damage of any part of the lamp. The lamp smokes or sparks. Flashing or failure of the LED light source.
1. Before using, connect the connector of the supplied adapter to the lamp and the adapter to the network.
2. The touch sensor switch is located on the lamp, which has 3 different levels of light intensity: the lowest one touch,
the medium with the double touch and the highest brightness can be achived with three touches. On the fourth touch,
the lamp turns off.
The product has a built-in display which powered by a button cell. the button cell is replaceable on the back side when
the display shows the time, date and temperature. Besides that if it has alarm and snooze function also, for which
several tones are evailable.
Set clock/ date:
Press the "S" button on the back to start setting. The clock gflashes to indicate that it has entered the setting mode.
You can then use the up and down arrows to set the clock. Pressing the "S" button again will set the minute, year,
month and day. If you have successfully set up, press the "S" button again to exit the setup mode.
Set alarm clock:
Press the "M" button on the back to switch to the "alarm" function. This is indicated by the "bell icon" in the top bar of
the display. By pressing the "set" button, you can set the clock by pressing again, the minute and then snoozing
function can be set between 1 and 60 minutes. As a last step, you can select the tone of the alarm. Once you have
selected the correct one, press the "S" button again. You can return to the exact time by pressing the "M" button. The
alarm lasts for 1 minute and then the snooze(1-60 minutes) function at the set intervals. If you press any of the clock
buttons during alarm, the alarm will be set only for the next day.
Temperature (°C/ °F)
Switch between Celsius and Fahrenheit by pressing the "down" arrow.
Time form(12h/24h)
Switch between 12h and 24h form by pressing the "up" arrow.
Cleaning/ Maintenance
The unit may require cleaning at least once a month, depending on the manner of use.
1. Power off the luminaire before cleaning! 2. Use a slightly moistened cloth to clean the outer surface of the luminaire.
Do not use any aggressive cleaners. Avoid getting water inside the product and on the electric components!
Pay attention to the polarity when replaceing battery! Do not use different kinds of batteries and/or used and now
batteries together! Do not open, burn and short circuit the batteries! It is forbidden to charge the batteries which are
not rechargeable! Risk of explosion!
1. Head of the lamp.
2. LCD display
3. Touch button
4. Control buttons
5. Button cell holder
6. Connector of the power adapter