Anker NEBULA Mars 3 Manual Del Usuario página 34

EN
Troubleshooting
① Fails to Power On
• The projector may be out of power. Charge the projector for 15-30
minutes and see if the LED screen lights up.
② Cannot Charge
• Use the included adapter and power cord to charge the projector.
• Try a different adapter (at least 180W) and power cord.
③ Cannot Connect to a Wi-Fi Network
• Place your projector within 16 ft / 5 m of the router and reconnect.
• Set your router to 2.4 GHz or 5 GHz and retry.
• Restart your projector and router and retry.
• Try a different Wi-Fi network or your phone's hotspot.
④ Blurry Image
• Slightly move the projector or press
autofocus.
• To manually adjust the focus, go to [Settings] > [Projector
Settings] > [Focus Settings] > [Manual Focus Correction], and use
and
• Adjust the projection angle and direction as well as the height of
the projector if necessary.
⑤ Distorted Image
• Update the firmware to the latest version via [Projector Settings] >
[Updates] > [Firmware Update].
• Go to [Settings] > [Projector Settings] > [Image Correction] >
[Perform Manual Keystone Correction].
• Move the projector left or right, or alter the tilt if necessary.
⑥ No HDMI Signal
• Use a different HDMI cable.
• Connect your projector with another HDMI playback device.
• Connect the HDMI playback device to your TV with an HDMI cable
to check if the device or cable are working.
32
on the remote.
on the remote to start