SUHNER ABRASIVE ATG 9-R Documentación Técnica página 27

There has been an overload while
working, therefore the performance
may be reduced temporarily. Reduce
working pressure.
Electronic safety shutdown: the
machine has SHUT DOWN by itself. If
The electronic
the slew rate of the current is too high
signal display is
(for example, if the machine sudden-
permanently on.
ly seizes or kickback occurs), the
machine switches off. Switch off the
machine. Switch it on again and con-
tinue to work as normal. Try to prevent
the machine from seizing.
4.3 r
ePAir
If the machine strict observance of the manufacturing and
testing method the tool should happen to fail, it must be
repaired by an authorized SUHNER agency.
4.4 w
ArrAnty
In the event of the tool being improperly handled, used
for purposes for which it is not intended and/or of the ser-
vice and maintenance instructions not being observed by
non-authorized persons, no warranty shall be in effect for
damages/consequential damages. Complaints can only
be honored if the machine is returned in the undisassem-
bled condition.
4.5 s
torAge
Temperature range: -15°C to +50°C
Max. relative air humidity: 90% at +30°C, 65% at +50°C
4.6 d / e
isPosAl nVironmentAl comPAtiBility
This machine consists of materials which can be dis-
posed of in a recycling process.
Before disposal, render the machine unusable.
Do not throw the machine into the garbage collec-
tion.
According to national regulations this machine
must be recycled in an environmentally-friendly manner.
Batteries and battery packs may not be disposed of in
domestic waste, burned, or discarded in water. Batteries
and battery packs should be collected, recycled, or intro-
duced to an environmentally friendly disposal cycle.
27