Dometic WAECO DC-Kit1 Instrucciones De Montaje Y De Uso página 23

DC-Kit1
6 Technical description
The DC-Kit1 extension kit enables Dometic roof air conditioners to be used
in vehicles with 12 Vg. The extension kit consists of the following compo-
nents:
 The ECL-76 charging current distributor with low voltage protection
regulates the power distribution between the starter battery, supply bat-
tery and lightmachine. This prevents the battery and the electronics in the
vehicle from overloading.
 The PP1002 inverter supplies the roof air conditioner with the required
input voltage of 230 Vw. The inverter generates the 230 V input voltage
from the 12 V on-board electricity supply in the vehicle.
The accompanying remote control can switch the inverter on and off.
The integrated priority circuit can be used for distributing the voltage in
the vehicle with two available power sources. If a mains voltage and volt-
age created by the inverter (vehicle battery) are both connected to the
device, the use of the mains voltage has priority. If the only voltage avail-
able is that generated by the inverter, the power supply from the battery
is used. This ensures that the limited power of the battery is not used
unnecessarily.
7 Installing and connecting the DC kit
A
NOTICE!
The DC kit may only be installed by a qualified workshop.
The following information is intended for specialists who are
familiar with the guidelines and safety precautions to be applied.
A
NOTICE!
Observe the information in the installation and operating manuals
when installing the components supplied
 PP1002 inverter
 MCR-9 remote control
 ECL-76 charging current distributor
and for your Dometic roof air conditioner
 CA1000
 FJ 1100
EN
Technical description
23