Cardin ZVL565.01 Manual De Instrucciones página 21

Setting a language:
Press a key to reach menu 7, press
keys and then press
Selection of codes for S500/S4XX remote control
The receiver is manufactured with the default setting for managing the S500 range: S504 for the RCQ433-XX
(433MHz) versions and S508 for the RCQ868-XX (868MHz) versions. If necessary, it can be configured
to manage the S4XX range compatible with the frequency in use: S449 (433MHz) or S486 (868MHz).
The remote control codes must be defined during installation before any other operation is carried out,
because all the codes stored must be deleted in the event of any changes.
To change the code, scroll through the menu using the
. Select the code using the
ENT
selection by holding down the
error will be displayed, indicating that the configuration of the memory is not compatible with the code
selected. Clear the memory with item 4) "DELETE MEM." The memory must always be deleted when
a code is changed. The receiver automatically disables the radio when the memory configuration does
not match the remote control code.
Retrieving a code memory module from another receiver
- power up the 3G/WiFi receiver with its original memory module installed;
- change the encoding method from S500 to S4XX;
- delete the memory module;
- switch off the 3G/WiFi receiver;
- replavce the opriginal memory module with one from your old receiver and then power up the 3G/WiFi
receiver;
If the encoding method is accidentally changed, restore the settings immediately without turning off the
receiver.
Input/channel information:
1234:A--- [ 3G]
The letters A,B,C,D, indicate the status of the outputs CHA, CHB, CHC, CHD. If a letter is shown the
output is active while if a hyphen '-' appears in its place the output is inactive. If no strip is inserted the
indications will be replaced by an empty space.
Setting the relays
The receiver uses an "ON/OFF" channel relay that maintains the status even in the absence of power. The
relay can be set to 'impulsive' or 'timer' using the SET STRIP menu. Each channel is independent and
can be set at will. To set the strips press a
keys choose the channel A-B-C-D you wish to set and then press
the keys choose the setting you wish to modify and press
parameter the current setting will be shown. For each channel you may set the mode, contact type and
power on reset parameters.
The MODE parameters define the function type the relay will use. Using the
the options and choose from: ON/OFF, IMPULSIVE, TIMER. Confirm the choice by pressing
the mode will be made active immediately. If you choose "timer" you will be taken to a submenu in order
to set the relay activation time (from 1 to 255 seconds). Using the
and press to confirm.
ENT
ENT
again (the default language is Italian).
ENT
keys and press
key for at least four seconds. At the end of the operation, the "E00"
The numbers 1,2,3,4, indicate the status of the inputs IN1..4. If a number appears
on the display, this means that the input is 'high' or 'open' while if a hyphen
appears on the display the input is 'low' or 'closed'.
, choose one of the five available languages using the
keys to item 11 "ENCODING" and press
. To complete the operation, confirm the
ENT
key to reach menu 5 and then press
ENT
ENT
21
. Using the
ENT
to access the settings. Using
to confirm. When you access a
keys, scroll through
keys choose the desired time
and
ENT