Publicidad
Idiomas disponibles
Idiomas disponibles
Cancelling the entire memory content:
• Scroll to menu 4) CANCEL MEM., press
and hold down the
appear on the display for several seconds.
At this point the entire memory content has been cancelled and the receiver has been reset to factory settings.
Transmitter information
When the receiver detects the activation of a transmitter it proceeds to activate the relay that corresponds to
the channel that has been received.
The following information appears on the LCD screen:
"CH": the transmitter channel is already memorised - "P" : memory location
"SN": transmitter identification code - "A" : Channel received then activated
This information remains on the display for a maximum of four seconds.
Memorizing more transmitters by using a previously memorised transmitter
This procedure allows you to enable a new transmitter (from a remote position) with the help of a transmitter
that has already been memorised in the system.
As the presence of the receiver is not required this procedure can be carried out in any remote location (for
example in your chosen sales outlet).
• The 'rapid memorization function' will either be enabled or disabled according to the value set in the
"PPT" parameter: as follows:
- begin the normal radio control memorization procedure; the indication "ACTIVATION 1..." should appear on
the display;
- to enable the function, press and hold down the
- to disable the function, press and hold down the
- after four seconds an indication will appear on the display specifying the status of the function "PPT ENABLE"
if it is enabled or "PPT DISABLE" if it is disabled;
- the completion of the operations using the 'rapid memorization function' will be confirmed by the symbol
*
'
' appearing on the display preceded by the letter pertaining to the activated channel (only valid for the
All rights reserved. Unauthorised copying or use of the information contained in this document is punishable by law
first activation);
- the received command will be carried out straight away.
• Procedures that are carried out via USB using the programming base ignore the "PPT" parameter setting
and will be carried out even if the 'rapid memorization function' has been disabled on the receiver.
To set up the new transmitter for rapid memorization, proceed as follows:
- Remove the upper cover from the transmitter to be memorised and from the transmitter that has already
been memorised as shown in the drawing below (det. a).
- Place the transmitter A, that has already been memorised in the receiver, near the new transmitter B (det. b).
- Using a pointed object press and release the MR button on both transmitters (in sequence or simultaneously).
- The orange LEDS on the transmitters will flash slowly.
- Press and release a channel button on transmitter A that is already present in the receiver (det. c).
- The led of the new unit B will remain lit for 3 seconds to confirm memorization (det. d).
Transmitter B will now command the receiver exactly like transmitter A.
1
3
2
ENT
key for four seconds, the indication "CANCELLING" plus a progress bar will
MR
A
B
and "CONFIRM?" will appear on the LCD display, press
key;
key;
All rights reserved. Unauthorised copying or use of the information contained in this document is punishable by law
MR
A
23
All rights reserved. Unauthorised copying or use of the information contained in this docum
B
Publicidad
