Publicidad
Idiomas disponibles
Idiomas disponibles
The CONTACT TYPE parameters define the type of contact that will be associated with the relay when
it is at rest. Using the
CONTACT NC. Confirm the choice by pressing
The POWER ON RESET parameters establish whether the relay will maintain the status when the receiver
is powered up or whether it will have to be reset and forced into the deactivated condition. Using the
keys scroll through the options and choose from: RESET ENABLED and RESET DISABLED. Confirm
the choice by pressing
TRANSMITTER CODE MANAGEMENT
Attention! Before memorising the transmitters for the first time check the encoding type and remember
to cancel the entire memory content.
Memorising a channel
• Scroll to menu "1) MEMORIZE TX", press
• Press the channel on the transmitter you wish to memorize, "Activation 2" will appear on the LCD display;
• Press the channel a second time (same TX, same channel), "SEARCHING....." will appear on the
display followed by one of the following:
-
the symbol '+' indicates that a channel has been added;
P
1
200000001
SN
the symbol '=' indicates that the channel already exists
-
P
1
200000001
SN
Note:
(1)
you cannot memorize a transmitter that has already been memorised: in this case the symbol '=' will
appear on the LCD display.
(2)
when the memory is completely full, the buzzer will sound 5 "beeps" one after the other and the
indication "E03- memory full" will appear on the display.
Cancelling a channel using a transmitter
• Scroll to menu "2) CANCEL TX", press
• Press the channel on the transmitter you wish to cancel, "Activation 2" will appear on the LCD display;
• Press the channel a second time (same TX, same channel), "SEARCHING....." will appear on the
display followed by one of the following:
-
the symbol '-' means the channel has been cancelled.
-
means that the channel is not present in memory.
NON TROVATO!
Cancelling one or more channels by means of memory position:
• Scroll to menu "3) CANCEL POS.", press
an arrow key
in the chosen position will appear on the LCD display (e.g. A B _ D).
• Using the
keys move the cursor to the desired channel, press
the letter. Repeat the procedure for all the channels you wish to cancel.
• Move the cursor to OK and press
with the asterisk symbol
Note:
(3)
If the chosen location is free 'FREE!' will appear on the display
(4)
If you cancel all the activated channels the transmitter will have been eliminated from the system and
"ELIMINATED!" will appear on the display.
keys scroll through the options and choose from: CONTACT NO and
and the mode will be made active immediately.
ENT
ENT
ENT
to scroll to the location you wish to cancel, press
. "WAIT....." will appear on the display and the channels marked
ENT
*
will be cancelled
and the mode will be made active immediately.
ENT
and "Activation 1" will appear on the LCD display;
ENT
(1) (2)
and "Activation 1" will appear on the LCD display;
and "Location 1" will appear on the LCD display, press
(4)
.
22
(2)
.
(3)
, the channels present
ENT
*
and the symbol
ENT
will replace
Publicidad
