Inoksan BYM102-HR Manual De Usuario página 13

• As shown in Figure 1, remove the nozzles
of the water sprayers and clean them from any
debris that may cause blockages.
• Clean the outer surfaces of the device with
a cloth soaked in soapy water. When cleaning the
device's surface, do not use abrasive detergents,
wire brushes, or other materials that may scratch
the surfaces.
• Clean the heating elements with a
descaling agent once a week.
• Remove and clean the pump's pre-filter at
regular intervals.
• If the device will not be used for an
extended period and there is a risk of freezing,
drain the washing pump and the boiler.
• If any hazardous condition is observed in
the machine, notify the authorized service. Do not
allow unqualified individuals to interfere with the
machine.
PROBLEM
1-Dishes are not clean.
2-Dishes are getting broken.
3-The device does not take
water.
4-The device continuously
takes water.
5-There is rusting on the
device surface
POTENTIAL PROBLEMS - CAUSES - SOLUTIONS
CAUSE
-Washing arms may be stuck.
-Washing water sprays may be
blocked.
-Rinsing water sprays may be
blocked.
-Detergent concentration may be
very high or insufficient.
-Filter may be blocked.
-Washing time may be insufficient.
-Proper tray may not have been
used.
-Machine may have
overloaded.
-Water inlet valve may be closed.
-Cover may not be
completely.
-Solenoid valve may be broken.
-Pressure stat may be defective.
-Pressure stat hose may have taken
in air.
-Improper chemical materials
may have been used.
• Over time, calcium and magnesium in the
water can cause limescale formation inside the
washing tank, boiler, and water pipes, affecting
the device's performance. Therefore, it is
necessary to have a qualified technician
periodically clean the limescale.
5. Child Safety
•
children under 8 years of age or
individuals with physical, sensory, or
mental disabilities, or lack of experience
and knowledge to use the device without
supervision.
•
children is dangerous.
•
not be done by children without
supervision.
-Check whether the dishes prevent arms from rotating.
-Clean the water sprays by removing the washing arm.
-Clean the water sprays by removing the rinsing arm.
-Check the hardness of water.
-Check the detergent amount.
-Remove and clean the filter.
-Select a longer wash period or repeat the same period.
-Be careful when selecting the tray.
-Comply with its capacity.
been
-Check/Open
closed -Check/Close
-Notify the authorized service.
-Notify the authorized service.
-Empty the water inside the tank and restart the device.
-Clean the device according to the instructions for use
13
It is dangerous and forbidden for
Playing with the device by
Cleaning and maintenance should
SOLUTION