Publicidad
Idiomas disponibles
Idiomas disponibles
LED display from Celsius to Fahrenheit
▪ You can set the desired temperature by pressing "
The temperature selected will increase/decrease by 1°C with each press of the buttons.
The control panel automatically displays the set temperature. To display the actual temperature,
simultaneously press and hold down the lighting and temperature adjustment buttons down for 3
seconds, located on the far right of the control panel. The display then shows the actual
temperature; after 3 seconds the set temperature appears again.
IMPORTANT: to optimize the operation of the appliance, it is important to set the
temperatures respecting a difference of 10°C maximum between the upper and lower
compartment (18 and 8°C for example).
Reversible door
This door of the appliance is reversible, the door is set to be hinged right at purchase,
you can change it to the left by following below instructions:
1. Close the door, remove the upper hinge cover and upper hole cover pad on top
side using a flat-head screwdriver.Remove the upper hinge by unscrewing 4pcs
of hex head screws, then remove the door from the cabinet carefully by opening
the door slightly and lifting it up and set it aside. Attention: The door is heavy,
handle it carefully with an assistant.
2. After door is removed, lie down the wine cooler on a soft mat. Remove the
lower hinge at the right bottom and door support at the left bottom.
3. Install the lower hinge to the left bottom and door support to the right bottom.
4. Move the hinge hole cap (at the top of the door) from the left side to the right
side. Move the door stopper (at the bottom of the door) from right side to the left
side by using a Philips screwdriver.
5. Hold the door carefully and place it on top of the lower hinge
6. Install the upper hinge at the left top of the cabinet, and cover the upper hole
with upper hole cover pad.
" or "
" of each zone
36
Publicidad
