TFA 60.2042 Instrucciones De Uso página 11

TFA_No. 60.2042_Anleitung 07.02.2024
Digital alarm clock with textile display and LED digits
• To activate and deactivate the alarm function press the ALARM button in alarm mode.
• The alarm symbol appears/disappears on the display.
• When the alarm is activated, the alarm starts to ring when the set alarm time is reached.
• Press any button (except SNOOZE) and the alarm will stop.
• If the alarm is not stopped manually, the ascending alarm tone automatically turns off after one minute
and will be reactivated at the same set time in the following day.
• The alarm symbol remains on the display.
• When the alarm rings, press the SNOOZE button and the snooze function is activated.
• Once the snooze function is activated, the alarm symbol will be flashing on the display.
• The alarm will be interrupted for the set time.
8. Display mode
• Each press on the MODE button in normal mode will change the display between: Time, date and auto-
matic dimming function OFF/ON.
• The display automatically switches back to the current time display after 10 seconds.
8.1 Automatic dimming mode
• Select the automatic dimming function OFF/ON by pressing the MODE button.
• By default, the automatic dimming function is disabled (OFF).
• To activate (ON) or deactivate (OFF) the function press the UP or DOWN button.
• If the auto dimming mode is activated (ON), the weak backlight turns on automatically at 6 pm and
switches off again at 6 am (default setting).
17:01 Uhr Seite 11
– 20 –
Digital alarm clock with textile display and LED digits
8.1.1 Setting time interval
• Press and hold the MODE button (display ON) to enter the setting mode for the automatic timer.
• The start time flashes. Press the UP or DOWN button to adjust the hours.
• Confirm the setting with the MODE button and press the UP or DOWN button to set minutes.
• Confirm the setting with the MODE button and set the end time in the same way.
• Confirm the setting with the MODE button.
• If the auto dimming mode is activated (ON), the weak backlight turns on automatically for the set time.
9. Display light
• Press the SNOOZE button to adjust the brightness in 3 levels:
HIGH (default)/MIDDLE/LOW.
• Attention: Continuous illumination of the display only works with USB-/mains connection.
• Battery operation: Press any button. The backlight turns on for 15 seconds.
10. Dots between the hour and minute indicators
• The two dots flash every second on the display.
• To activate or deactivate the function, press the UP button for 2 seconds in normal mode.
11. Care and maintenance
• Clean the device with a soft damp cloth. Do not use solvents or scouring agents.
• Remove the batteries if the device will not be used for an extended period of time.
• Store the device in a dry place.
– 21 –