Kripsol PHB13 Manual Del Usuario página 5

EN
••
• WARNING – Carefully read the instructions in this manual and those on the device. Non-com-
pliance with the instructions may result in injury.
• WARNING – This document must be given to all pool users, who should keep it in a safe
place.
• WARNING – Always turn off power to the device before handling the electrical installation.
• WARNING – This device is not intended for use by those with reduced physical, sensory or
intellectual capacities (in particular children) or by those who do not have the suitable experi-
ence or knowledge, unless they are supervised or have received instructions in how to use the
device by the person responsible for their safety.
• WARNING – All electrical connections must be made by an authorized and qualified profes-
sional electrician, according to the standards in force in the country of installation or, in de-
fault, according to the international standard: IEC 60364-7-702: LOW-VOLTAGE ELECTRICAL
INSTALLATIONS. REQUIREMENTS FOR SPECIAL INSTALLATIONS OR LOCATIONS. SWIM-
MING POOLS AND FOUNTAINS.
• WARNING – Ensure that children cannot play with the device. When handling it, keep your
fingers away from the openings and moving parts, and make sure no foreign objects enter the
device.
• WARNING – If the power cable is damaged, to eliminate danger it must be replaced by the
manufacturer, their maintenance agent or by a person with an equivalent qualification (see
paragraph below: Procedure for replacing the bulb.
• WARNING – Only operate the spotlight when it is submerged underwater.
• WARNING – The bulb must be connected to a safety transformer (12V AC).
• WARNING – It may be necessary to ask the opinion of a qualified person regarding the
installation.
• WARNING – The connection box is not included. It must have screw terminals, at least bipo-
lar, for a minimum rated voltage of 12Vac and 1.5 A, for a minimum cross-section of 1.5mm². It
must conform to EN 60998-2-1, with a minimum IP54, but never in contact with water.
Reference 061511213000
Model PHB13
Consumption
Power supply
No. of LEDs
Lumens
Colour
Application
Spotlight
assembled
Remote control
included
This pool light contains
an ALP01removable LED
Energy efficiency bulb with a D energy
rating.
TRANSFORMER POWER:
The transformer used must have a secondary output voltage of 12V (12.5V for some models). The power must be appropriate for the power of the spotlight(s) that will
be connected (minimum power = 23VA for a white bulb and 28VA for an RGB bulb).
In all cases, the sum of the spotlight powers must remain less than or equal to the transformer power.
ENVIRONMENTAL INFORMATION:
Provision on waste electrical and electronic equipment from professionals. In accordance with Directive 2012/19/EU on the management of waste electrical
and electronic equipment, this projector must be taken to a separate collection point. Please contact your dealer for more information.
5
THE DEVICE IS DESIGNED FOR USE IN POOLS ONLY.
061511113200 061521213010
PHBM13 PLB13
13W
60
1450
Cool white
Concrete
D
No Yes
No
ALP01
WARNING: Electrical risk.
Non-compliance with these instructions
may lead to serious injury or death.
061521113200 061512213000
PLBM13 PHC13
12 VAC
Liner / Fiberglass
A
No Yes
G
D
A
G
ALP01
061512113200 061522213010
PHCM13 PLC13
16W
90
600
RGB
Concrete
No Yes
Yes
The EU2019/2015 and EU2019/2020 regulations
do not apply to this RGB light.
061522113200
PLCM13
Liner / Fiberglass
No Yes