Publicidad
Idiomas disponibles
Idiomas disponibles
Step 4. Dishwasher installation steps
Please refer to the specified installation steps in the installation
Please refer to the specified installation steps in the installation
drawings.
drawings.
1. Affix the condensation strip under the work surface of cabinet. Please ensure the
condensation strip is flush with edge of work surface. (Step 2)
2. Connect the inlet hose to the cold water supply.
3. Connect the drain hose.
4. Connect the power cord.
5. Place the dishwasher into
6. L
Level the dishwasher. The rear foot can be adjusted from the front of the
dishwasher by turning the Philips screw in the middle of the base of dishwasher
use
a
Philips screw
the front feet until the dishwasher is level.
7. Install the furniture door to the outer door of the dishwasher. (Step 7 to Step 10)
8.
Adjust the tension of the door springs by using
clockwise motion to tighten the left and right door springs. Failure to do this could
cause damage to your dishwasher. (Step 11)
9. The dishwasher must be secured in place.
9
the cabinet
driver
. To adjust the front feet, use a flat screw driver and turn
23
.
(Step 5 to Step 6)
a Philips screw driver
Fix the side with
turning in a
screws
.
Publicidad
