Supplied Accessories; Attaching The Base; Symbols Used In This Manual; Fixing The Unit On Your Furniture - Sylvania LC320SS1 Manual Del Propietário

Supplied Accessories
Owner's manual Quick Start
(1ENN25841) { LC320SS1:1 ENN25842
/ LC260SS1:1ENN26283
Remote control Registration card
(N H 200U D) (1 EPIN 24700)
Batteries Screw kit
(AAA, 1.5V x 2_) for attaching the base
LC320SS1:1 ESA19881
LC260SS1: I ESA23705
If you need to replace these accessories, please refer
to the part No. with the illustrations and call our toil
free customer support line found on the cover of this
manuak
Note
• If you lose the screws, please purchase M4x20 Phillips head screws at your
Iota1 store,
Symbols Used in this Manual
The following is the description for the symbols used in
this manual. Description refers to:
_# : DigitaITV operation
: Analog / Cable TV operation
If neither symbol appears, the operation is applicable to
both.
Attaching the Base
You must attach the base to the unit to have it as a table top
unit. Be sure the front and rear of the base match the proper
direction.
1 Spread a thick and soft
cloth over a table as
shown.
Place the main unit face
down onto it. Make sure
not to damage the screen.
At least 2_people are
required for this step. , ............
2
arrowbottomintoInsertbase 2_ (_)), of the hooks holes, thenmain under (shown move unit the the b y @ _ .............. __:'?
base in the direction as
shown by arrow _2} until it _.
stops and the 4 mounting _J
holes are aligned, iViake O
sure not to put the AC
power cord between the
base and the unit.
3
Drive Phillips pan screws
into the 4 threaded holes
at the bottom of the base
until they are tight.
To remove the base from ths unt
• Unscrew the Phillips pan screws on step 3.
After the screws are removed, move the base in the opposite direction as
shown by arrow (2) on step 2, then pull the base up toward the rear- of the
unit. Be careful not to drop the base when you remove it.
Note
• When attaching the base, ensure that all screws are tightly fastened. If the
base is not properly attached, it could cause the unit to fall. resulting in
injuries as well as damage to the unit.
• Make sure to use a table which can support the weight of this unit and is
larger than this unit.
• Make sure the table is in a stable location,
• When attaching the base, ensure that FRONT t written on the base is
upward. Jf it's not upward, the 2 hooks don't fit in the base,
ZI
o
_z
Fixing the Unit on Your Furniture
Screw this unit on your furniture tightly using wood screws
(not supplied) in the 2 holes atthe back of the base as shown,
• Recommended screw dimension : 5,1 × 20 mm
rear of this unit
holes
Note
• When you remove this unit make sure to unscrew the wood screws fi_om
yourWood Stand, Furn ture and other wood tern.
5
EN