Publicidad
Idiomas disponibles
Idiomas disponibles
Figure 9.
FADC/FAWS option – If Equipped
(Figure 10,11)
Tools Required:
Torx screwdriver T20, Torque wrench
inch-lb.
1.
If driver housing lid if supplied with latches, undo all the
latches and let the door swing out. If the driver housing
lid is supplied with screws, use torx bit to loosen all
door screws. Note the door screws are retained in the
door so do not completely remove them from the door
(Fig 10).
2.
FADC/FAWS switch has a knob with ten settings as
indicated 1 thru 10 (Fig 11). Rotate switch to desired
setting needed (see table below for reference).
FADC Position
Percent of Typical Lumen Output
1
25%
2
48%
3
56%
4
65%
5
75%
6
80%
7
85%
8
90%
9
95%
10
100%
Installation Instructions – IFLD Infrastructure Flood
3.
If the driver housing lid had screws, use Torx bit and
tighten it back and tighten to 22 inch-lbs. If the driver
housing lid had latches, latch the door back in place.
N
ote:
Ensure no wires get pinched between the Lid and
gasket.
LID Driver housing
FADC Option
Gasket LID
driver housing
**
(4)Door latch
**Cooper will provide either
door latch or door screws
not both
Figure 10.
Figure 11.
Cooper Lighting Solutions
**
(8)10-24 X .875
Tightning torque 22-24 in-lbs
IB506022EN
Installation instructions
Hinge
assembly
5
Publicidad
