Hotpoint Ariston FT 850.1/HA Manual De Instrucciones página 14

L
N
3. Secure the cable by fastening the clamp screw.
4. Close the cover of the terminal board.
1. Open the terminal board
by inserting a screwdriver
into the side tabs of the
cover. Use the screwdriver
as a lever by pushing it
down to open the cover
( see diagram).
2. Install the power supply
cable by loosening the
cable clamp screw and
the three wire contact
screws L-N- .
Connect the wires to the
corresponding terminals:
the Blue wire to the
terminal marked (N),
the Brown wire to the
terminal marked (L) and
the Yellow/Green wire to
the terminal marked
(see diagram).