Orion 14740 Guía De Servicio página 3

INTRODUCTION
The 14740 meter is an oval gear model with electronic
register.
INSTALLATION
The meter can be connected to a control gun or installed
directly in the distribution pipe. It is recommended to
install a cut-off valve before the meter to facilitate its
maintenance or repair.
BATTERIES
The batteries location is shown in the following figure:
A
ATTENTION: The meter is supplied without the batteries
mounted. Follow the procedure below to install them.
1. Loosen the threaded caps (A).
2. Install the provided batteries (B) checking the polarity (C)
indicated at the measuring chamber bottom.
3. Put in place again the screw caps (A).
Alentec & Orion AB Grustagsvägen 4, SE-13840, Älta, SWEDEN · info@alentec.se · www.alentec.com
B
The meter requires two 1.5 V batteries and size LR 03 as
the power supply source. They are placed in two watertight
housings located in the measurement chamber. The
threaded caps provide watertightness and prevent the
batteries from being removed accidentally in the event of
impacts or vibrations.
EN
C
3
R. 09/23 105 300