Texas Instruments TI-5006 II Manual De Instrucciones página 4

6. Insert the end of the paper into the slot under the printing mechanism.
7. Press & until the paper feeds out of the top of the printer compartment.
8. Feed the end of the paper through the slot behind the clear plastic
"window" of the printer compartment cover. Then snap the
compartment cover back onto the unit.
9. Place the paper roll on the paper holder.
To prevent damaging the printer (which may void the warranty),
Note
turn the printer off when operating the calculator without paper. To turn
it off, press S so that
Replacing the Ink Roller
1. Press V.
2. Remove the printer compartment cover.
3. Remove the ink roller from the right
side of the compartment. Insert your
index finger, nail down, under the tab
on top of the ink roller. Gently lift the
ink roller out of the compartment.
4. Lower the new ink roller (IR-21) into
the compartment and align the hole
in the ink roller with the pin in the
compartment. Press down until it
snaps into place.
5. Replace the compartment cover.
Never refill or moisten the old ink roller. This can damage the
Warning
printing mechanism and void the warranty.
is not displayed.
PRINT
3