Only use the device for its intended purpose. All other uses may lead to short circuits, burns, electroshocks,
lamp explosion, crash, etc. Using the device in an unauthorised way will void the warranty.
Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and the
dealer will not accept responsibility for any ensuing defects or problems.
Use the original packaging if the device is to be transported.
Keep this manual for future reference.
4.
Features
LED ceiling panel light
easy installation: for system ceiling
high-brightness LEDs
2 sides - 192 pieces SMD 3014 (LEDA61xW)
o
1 side - 216 pieces SMD 3014 (LEDA62xW)
o
LED driver: high-quality constant current LED driver
optional cable set for floating installation: LEDA61C
housing: aluminium
diffuser: frosted PS (polystyrene)
5.
Installation
Refer to the illustrations on page 2 of this manual.
A
panel light
B
power adapter
C
to the mains
D
to the panel light
E
suspension wire
F
ceiling mount
5.1
Installation in a System Ceiling
To install in a system ceiling, proceed as follows:
1. Check if the construction is sturdy enough to carry the weight of the panel light, and if the panel fits the
mounting location.
2. Remove a ceiling panel where you want to install the panel light.
3. Mount the power adapter to a suitable spot in the ceiling.
4. Provide suitable cabling from the mains and connect it to the power adapter.
Warning: Provide a secure connection. The mains circuit must be earthed and protected with a suitable
fuse.
5. Connect the power adapter to the panel light. Screw the protection cap tightly over the connection.
6. Remove the protective film from the back of the panel light.
7. Place the panel light in the system ceiling.
The panel light is now ready for use. It lights up when switched on.
a
V. 02 – 07/09/2015
LEDA61CW/LEDA61NW/LEDA61WW/LEDA62NW
G
panel holder
H
cap with screw
I
wire holder with wire
J
panel light attachment
K
mounting hole graph
b
4
©Velleman nv