Publicidad
Idiomas disponibles
Idiomas disponibles
3. Provide suitable cabling from the mains and connect it to the power adapter [C].
Warning: Provide a secure connection. The mains circuit must be earthed and protected with a suitable
fuse.
4. Drill four holes [K] in the ceiling for the ceiling mounts [F]. Insert a plug [L] in each of the holes.
5. Insert a ceiling screw [M] in each of the wire holder caps [H].
6. Insert a suspension wire [E] in each one of the wire holders [I].
7. Screw all wire holders [I] onto the holder caps [H] in order to complete the ceiling mounts [F].
8. Insert a wire into each of the panel attachments. On all suspension wires, slide the clamp on the wire and
fix tightly with the appropriate screw [N]. See figure [J] for the final result.
9. Cut of the excess wire ends if necessary. Caution: Keep at least 10 mm of wire showing, so that you can
still easily adjust the wire length later if necessary.
10. Connect the power adapter [D] to the panel light.
11. Remove the protective film from the back of the panel light.
The panel light is now ready for use. It lights up when switched on.
5.3
Framed Installation
We recommend using the Vellight LEDA61AF or LEDA62AF frame. To install in a frame, proceed as follows:
a
c
1. Check if the construction [A] is sturdy enough to carry the weight of the panel light and frame, and if the
panel fits the mounting location.
2. Use the aluminium frame to take the mounting holes measurements. Drill the necessary mounting holes
using the appropriate tools (not incl.). Insert a nylon plug (not incl.) [B] in each of the holes. Fix the
aluminium frame [C] to the roof using M4 screws (not incl.) [D].
3. Slide the panel light into the aluminium frame.
4. Connect the panel light to the power supply.
5. Close the aluminium frame.
6.
Cleaning and Maintenance
This luminaire does not have a built-in device to disconnect it from the electric mains. Make sure to
electrically isolate the luminaire before installation or maintenance activities are performed.
All screws shall be tight and free of corrosion.
The housing, the visible parts, the mounting supports and the installation location (e.g. ceiling, suspension,
etc.) shall not be deformed, modified or tampered with; e.g. do not drill extra holes in mounting supports,
do not change the location of the connections...
Mechanically moving parts must not show any signs of wear and tear.
The electric power supply cables must not show any damage. Have a qualified technician maintain the device.
If the protective shield is damaged, disconnect the lamp immediately from the mains. Do not use the lamp
with a cracked or broken protective shield. The protective shield is not replaceable.
Wipe the device regularly with a moist, lint-free cloth. Do not use alcohol or solvents.
There are no user-serviceable parts.
Contact your dealer for spare parts if necessary.
V. 02 – 07/09/2015
LEDA61CW/LEDA61NW/LEDA61WW/LEDA62NW
b
d
6
©Velleman nv
Publicidad
