Installation And Operating Conditions Of The Appliance - Fagor 3WCI-8630N Manual De Instrucciones

• Disable the appliance before disposing of it. Unplug the
appliance from the power supply and cut off the power
cord. To prevent children or animals from being trapped in
the appliance, remove the doors, hinges and locks.
INSTALLATION AND OPERATING
CONDITIONS OF THE APPLIANCE
• Connect the appliance to the power supply 24 hours after unpacking and setting
in the final location.
• Take the product out of the package, remove the scotch tape protecting the door
and the equipment. Any remaining adhesive stains may be removed with a mild
washing agent.
• Clean the interior surface of the cooler and the elements of the equipment with
a washing agent dissolved in lukewarm water, then wipe it dry.
• Place the cooler on an even, flat and stable surface, in dry, aired and shaded
room, far from the heat sources such as: oven, hob, central heating radiators,
central heating pipes, hot water installation, etc.
• On the exterior surface of the product may be a protective foil, this foils should
be removed.
• Make sure the appliance is placed in a horizontal position by screwing in the 2
adjustable front legs (fig. 1)
• Keep free space on the sides and rear of the appliance (see installation drawing)
• When you install your wine cooler inside a furniture cabinet, make sure that the
ventilation grille located in the bottom of the appliance is not blocked.
• Odours may be released when you first start your appliance. It will dissipate
when the interior of the appliance cools down
• When you first start your wine cooler, the compressor will run continuously until
the desired temperature is reached inside the chamber
• When you unplug your appliance from the power supply, it is recommended to
wait 5 minutes before you plug it back in. This will reduce the risk of damage to
the compressor.
• On selected models, the correct temperature will be shown on the display only a
few hours after the wine cooler has been put into operation
• This appliance should be connected to AC 220-240V 50Hz supply socket. The
socket must be fitted properly, and must be supplied with an earthing conduit
and a 10A fuse.
• It is a legal requirement that the appliance is properly earthed. The manufacturer
will not be held liable for any damage or injury which may result from the failure
to fulfil this requirement.
• Do not use adapters, multiple sockets and two-wire extension leads. If it is nec-
essary to use the extension lead, it must be equipped with a protection ring and
a single socket and must have a VDE/GS safety certificate.
• If an extension lead is used (with a protection ring and safety certificate), its
socket must be located at a safe distance, away from the sinks, and must not be
in a place where it could be flooded by water or waste water.
• Make sure the appliance can be easily disconnected from the mains, either by
pulling the plug out of the mains socket, or by switching the two-pole switch off.
31