Set The Temperature - Two-Zone Refrigerator; Save Settings Function; Open Door Alarm; The Wrong Temperature Alarm - Fagor 3WCI-8630N Manual De Instrucciones

set (target) temperature will be shown on the display.
• The display is flashing — the temperature inside the refrigerator is shown. The
display is steady — the set (target) temperature is shown.
Set the temperature — two-zone refrigerator
Press to adjust the temperature in the upper refrigeration zone by 1°C**
Press to adjust the temperature in the lower refrigeration zone by 1°C**
The range of temperature that can be set varies as follows:
Upper zone: 5-10°C
Lower zone: 10-18°C
• Each time the button is pressed, the temperature in the zone increases by 1°C.
When the temperature reaches the upper limit (10°C for the upper zone or 18°C
for the lower zone), the temperature will cycle back to the lowest possible set-
ting, ie 5°C for the upper zone or 10°C for the lower zone.
• To check the current temperature inside the chamber, press and hold for 3 sec-
onds (for the upper zone) or
current temperature. After 5 seconds, the set (target) temperature will be shown
on the display.
• The display is flashing — the temperature inside the refrigerator is shown. The
display is steady — the set (target) temperature is shown.
Note:
• If the appliance is disconnected from the power supply or if there is a power out-
age, wait 3 to 5 minutes before reconnecting the appliance to the power supply.
It will not be possible to start the appliance earlier.
• When you plug in the appliance for the first time, there may be a difference be-
tween the temperature shown on the display and the actual temperature. This is
normal and after a few hours of operation, the temperature displayed should be
accurate.

Save settings function

If power will lose, the set temperature values will be remembered until the power
returns.

Open door alarm

If you forget to close the door or it is closed incorrectly, after 5 minutes the appliance
will beep. Close the door correctly.

The wrong temperature alarm

If the temperature inside the chamber is higher than 23°C, the display shows "HI", an
hour later an beep signal will appear. If the temperature drops below 0°C inside the
chamber, the display shows "LO" and the alarm will sound.
for the lower zone. The display will show the
35