Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly
1 Flush through the supply pipes.
2 Place the mixer including the sealing washer in
position on the basin.
3 Slip the fixation piece including the washer over
the threaded pin and tighten the nut.
4 Connect the supply pipes to the angle valves;
cold right - hot left.
5 Connect the pull rod to the pop-up waste.
Technical Data
Rate of flow with waterdimmer:
Rate of flow without waterdimmer:
Operating pressure:
Recommended operating pressure:
Test pressure:
Hot water temperature: max.
Recommended hot water temp.:
Hansgrohe two handle mixers can be used together
with hydraulically and thermically controlled continuous
flow heaters if the flow pressure is at least 1.5 bars.
If the continuous flow heater makes any problems or
there comes not enough water, the waterdimmer (flow
limiter 7a) located behind the mousseur must be removed.
To simplify installation pressure hoses no. 13098000
are available.
English
Spare parts
1
2
3
4
5
6
7
8
9
7 l/min 3 bars
9.1 pull knob
14 l/min 3 bars
9,2 pull rod
max. 10 bars
10 fixation cpl.
1 - 5 bars
16 bars
XXX = Colors
80° C
65° C
000 chrome plated
010 chrome/gold/jewel
030 chr. plated/blue
060 chr. plated/black
070 chrome/green
090 chrome plated/gold plated
330 blue
430 red
450 white
480 yellow
490 white /gold
610 black
680 aranja/gold plated
840 fine brass
880 satin chrome
890 satin chrome/gold plated
knob for cold water Mondaro
knob for hot water Mondaro
knob for cold water Uno
knob for hot water Uno
spout Mondaro
spout Uno
washer
aerator cpl.
aerator gold plated
ELASTOP stop unit
pull rod cpl.
18291XXX
18292XXX
13291XXX
13292 XXX
95035XXX
92035XXX
92646000
13085000
94980990
94149000
92620XXX
94066XXX
94067XXX
94701XXX
Publicidad
