Eureka ATOM W 65 Instrucciones De Manejo página 33

EN
3 DESCRIPTION OF THE APPLIANCE
1. Container lid
2. Container for coffee beans
3. Coffee bean container
opening/closing tab
4. Grinding adjustment knob
A. Selected dose grams display
B. Grams decrease button
C. Dose 1 selection
D. Dose 3 selection
E. Blocked dose adjustment
F. Active alarm
G. Grams increase button
H. Dose 2 selection
4 ADJUSTMENTS AND USE
4.1 PRELIMINARY OPERATIONS W 65/75
Before starting work, the machine must be set up according to the type of coffee blend
(roasting level) and grinding.
• Insert the container for coffee beans (2) into its seat (Fig.2) positioning it with the
hole aligned with the screw located behind it (Fig.3) and lock it in place by tightening
the screw.
• Push the tab (3) to prevent the coffee beans from passing through (Fig.4).
• Remove the lid (1) from the container (2) and fill it with coffee beans.
• Put the lid (1) back on and pull the tab (3) to allow the coffee beans to pass through.
• Adjust the height of the filter holder fork by loosening the two screws beneath it (8)
(Fig.6).
4.2 GRINDING DEGREE ADJUSTMENT
To adjust the grinding degree, use the adjustment knob (4), turning it clockwise to make
the powder finer or counter-clockwise to increase the grain size as indicated on the
knob (Fig.7). The adjustment is without stops; it must be carried out gradually, grinding
a little coffee every 2 notches at the most.
ATTENTION
If the knob is turned by one full turn with the motor stopped, the machine may
stop.
5. Touch screen display
6. Dispensing nozzle
7. Ignition button
8. Filter holder fork
I. Continuous dose selection
J. Menu access
K. Next page
L. Previous page
M. Technical menu access
N. Menu exit
O. Back
33