Eureka ATOM W 65 Instrucciones De Manejo página 34

4.3 TURNING ON THE MACHINE
Turn the switch (7) to the on position.
When the appliance is switched on for the first time, it will be set to the mode set at the
time it left the factory and, in any case, during subsequent starts, it will always be set to
the last mode before it was switched off.
When switched on, the display shows the operating screen.
4.4 DOSES OPERATION
Select the dose to be dispensed using the respective buttons (C), (H) o (D). Rest the cup
of the filter holder on the fork (8), making sure that it is precisely under the dispensing
spout (6). Dispensing starts automatically after a few seconds and ends when the grams
set in the programming are reached.
ATTENTION
To start a new dispensing it is necessary to remove the filter holder, wait
approximately two seconds and reinsert it.
ATTENTION
It is possible to stop automatic dispensing before the grinding grams have run
out. During dispensing, press the selected dose button, or the front activation
button, to stop dispensing. The display shows the grams ground up to the pause.
Press the button again to resume dispensing for the remaining grams.
With the dose paused it is only possible to change the selected dose if the weight
of the ground coffee has not exceeded the value of the dose to be selected.
Otherwise, if the single grinding time has already been exceeded, the grinding
will stop.
ATTENTION
If the grinding is not restarted or the filter-holder is removed within 30 seconds,
the system will reset.
ATTENTION
If the filter holder is not inserted correctly, the grinding does not start and the
lines appear
holder, wait approximately two seconds and reinsert it.
ATTENTION
Grinding must only start after inserting the filter holder.
To reset the system, simply remove the filter holder from the fork.
34
before dispensing. To release the grinding, remove the filter
EN