Worx Nitro WG581E Manual Original página 8

drawn into the air inlet.
Keep long hair away from
the air inlets.
c) Obtain ear protection and
safety glasses. Wear them
at all times while operating
the machine.
d) Operate the machine in a
recommended position and
only on a firm, level surface.
e) Do not operate the machine
on a paved or gravel surface
where ejected material
could cause injury.
f) Before using, always
visually inspect to see,
that the fasteners are
secure, the housing is
undamaged and that guards
8
and screens are in place.
Replace worn or damaged
components in sets to
preserve balance. Replace
damaged or unreadable
labels.
3) Operation
a) Before starting the machine,
make certain that the
feeding chamber is empty.
b) Keep your face and body
away from the feed intake
opening.
c) Do not allow hands or any
other part of the body or
clothing inside the feeding
chamber, discharge chute,
40V Cordless Blower
or near any moving part.
d) Keep proper balance and
footing at all times. Do not
overreach.
e) Always stand clear of
the discharge zone when
operating this machine.
f) If the machine should start
making any unusual noise
or vibration, immediately
shut off the power source
and allow the machine to
stop. Remove the battery
pack from the machine
and take the following
steps before restarting and
operating the machine:
i)inspect for damage;
ii)replace or repair any
damaged parts;
iii)check for and tighten any
loose parts.
g) Do not allow processed
material to build up in the
discharge zone; this may
prevent proper discharge
and can result in kickback
of material through the
intake opening.
h) If the machine becomes
clogged, shut-off the
power source and remove
the battery pack from the
machine before cleaning
debris.
i) Never operate the machine
with defective guards or
EN