SOLAC CVG 9800 Instrucciones De Uso página 17

• Unplug the CVG and fill the tank with the beaker that is supplied Fig 1 (8),
in the vertical position as shown in figure Fig 3.
• When the tank is full, the icon does not disappear from the display until you
press the On – Off switch and start ironing again.
• If the appliance were to run out of water completely, you would hear
a strange noise from the micro-pump. In this case, press the On-Off
switch, unplug the appliance and fill the tank with water. When you
press the On – Off switch again, this noise will disappear.
ANTICALC - SYSTEM
• The Compact Vapor Generator is fitted with a replaceable anticalc – system
consisting of a resin filter, which retains the limy substances in the water,
preventing these from reaching the steam chamber in the sole-plate and
thereby extending the life of your CVG. If you so wish, on this model you may
replace the resin so that the CVG is kept in optimum condition. If you want
to replace the resin, we recommend you to do it every 6 months. Chang-
ing the resin does not mean that you may overlook the advice about water
hardness given in the section "BEFORE STARTING TO IRON" .
• In the event of not changing the resin of this CVG, it will be subject to
the effects of scale just like as in other ironing systems.
• For replacement and before removing it, make sure there is no water
in the tank.
• Turn the part, situated in the heel of the appliance, in an anticlockwise
direction as far as it will go, and the arrow lines up with the open padlock
(approx. 180º) and pull it back.
• To replace it, line up the arrow with the open padlock and turn it in a clock-
wise direction, following the directions in the drawing, pressing the part in-
wards at the same time, until reaching the padlock closed position Fig 9.
• When the filter is in place, make sure that it DOES NOT STAND OUT of
the back of the iron, otherwise you will not have fitted it properly and
water will leak from the tank.
CLEANING
A) Sole-plate
• Unplug the iron and let it cool down.
• Use environment-friendly clay-based products to clean the sole-plate.
B) Outside
• To clean the outside of your CVG, use a cloth moistened in soapy water.
• Do not clean with abrasive chemical products or solvents as it may attack
certain plastic parts and / or remove some of the marks and / or indica-
tions.
CVG9800 17
17
9/4/08, 10:03:56