Publicidad
Idiomas disponibles
Idiomas disponibles
INSTRUCTIONS FOR USE
ISTRUZIONI PER L'USO
TECHNICAL DATA
NOMINAL POWER SUPPLY VOLTAGE
FREQUENCY
POWER
TEMPERATURES (at 5 mm from blowpipe):
AIR FLOW
KEY TO SYMBOLS
1 - Blowpipe
2 - Overheat protection
3 - Tool body
4 - Control panel
5 - Operating mode selector switch
6 - Power supply cable
7 - LCD display
8 - Work parameter saving button
9 - Function selector button
(only with active Step II)
10 - Decrease temperature
11 - Increase temperature
12 - Increase air flow
13 - Decrease air flow
Display indicators
A - Air flow indicator
B - Set temperature indicator
C - Memory number
D - Data saving indicator
ACCESSORIES
The heat guns are supplied with a set of accessories for controlling the airflow according to the job to be carried out.
Before installing/removing the accessories, make sure that the blowpipe is cold.
When using accessory D, check that the flow coming out of the side vents cannot harm people or damage
objects nearby.
USAGE
Connect the power supply cable to the mains socket, checking that the mains voltage matches the voltage stated on
the heat gun or in the TECHNICAL DATA table:
• Use switch (5) to turn on the heat gun.
• Select the required mode bringing the switch to:
• Step I
• Step II
• Bring the blowpipe near the working area.
• When the operation is complete, bring the switch back to "0" to turn the heat gun off.
• Place the heat gun on the supporting surface with the blower turned upwards, and leave it to cool down.
When using the heat gun, do not touch the blowpipe.
220 – 240 V AC
50/60 Hz
2000 W
Step I:
50 °C
Step II: 50 -650 °C
Step I:
250 -500 L/min
Step II: 250 -500 L/min
EN
I
9
Publicidad
