Craftsman 320.39588 Manual Del Propietário página 13

PRESSURE CONTROL (Fig. 4}
Your tool is equipped with pressure
control indicator lights. The
indicator lights will Betyou know if
you are applying the proper amount
of pressure during operation.
If only the green indicator Bight
illuminates, it indicates that you
are applying the correct amount
of pressure.
If the yellow and the green lights
both illuminate, they indicate that
you are applying a little more
pressure than needed.
Fig. 4
Pressure
control
indicator
If the red, green and yellow lights all illuminate, they indicate that you are applying
too much pressure and you need to Bessen the pressure as soon as possible.
,_ CAUTION: To prevent possible personal injury or tool or workpiece damage,
always be sure that the pressure control illuminates only green during tool operation.
ATTACHING THE SANDPAPER
3.
4.
_WARNING: Always inspect the sandpaper before attaching it. Do not use
the paper if it is torn or defective.
The non=adhesive sandpaper clamps to the front and back of the platen.
1. Disconnect the sander from the power source.
WARNING: Failure to unplug the sander could result in accidental starting,
causing possible serious personal injury.
2. Remove any dust or debris from the platen.
The paper clamp levers are located on each side of the sander and are
locked into slots on top of the platen.
5.
Raise these two levers "up"
and disengage them from
the slots in the platen. This
will release the tension on
the paper clamps that hold
the paper in position on the
underside of the platen (Fig. 5).
Insert the front end of the
sandpaper approximately
1/2 in. under the front
paper clamp.
paper
clamp
Paper
clamp
lever
13