Craftsman 320.39588 Manual Del Propietário página 14

6.
7.
8.
Lift up on the lever that controls the front paper clamp and lock it back into the
slot on the platen. This will securely clamp the paper to the front of the platen.
Smooth out the sandpaper by pressing it tightly against the bottom of the
platen (front to back).
Insert the back end of
the sandpaper into the
back paper clamp, fit the
sandpaper as tightly as
possible, and lift up on the
back clamp lever to lock it
into place. This will securely
clamp the paper to the back
of the platen. The sandpaper
should now be positioned
tightly against the underside
of the platen from front to
back and securely clamped in
place (Fig. 6).
Fig. 6
Paper
goes
under the
clamp
Raise lever up
to clamp paper
PAPER PUNCH
A paper punch is provided with
the sander so you can punch
properly aligned holes into the
sandpaper. This is done after the
paper is installed onto the sander.
To punch holes, line up the front
and side of the sander over the
paper punch as shown in Fig. 7,
then lower the sander onto the
punch template while applying
pressure. Make sure that the holes
are punched all the way through
the paper and clear the holes in
the sandeds platen.
NOTmCE: Punching holes
propedy is a necessary step for
the dust-collecting system to
operate properly.
Fig. 7
Paper punch
14