WARNINGS
These operating instructions are intended to familiarise you with the operation of this
product. Keep this manual in a safe place so that you can refer to it at any time.
•
Do not begin installation until you have read and understood the complete
operating instructions.
•
Carry out the installation with another person to ensure safe installation.
•
Remove the product from its packaging and remove all packaging material. Make
sure that no packaging material is on or in the product. If you notice any damage to
the packaging, also check whether there is any damage to the product. If you notice
any external damage to the unit or any unexpected or unusual functioning, the
product must not be used any longer. Contact the dealer immediately, from whom
you purchased the product or celexon directly (Web: www.celexon.co.uk, Mail:
info@celexon.co.uk) for further information.
•
To ensure trouble-free operation, the product must only be used indoors, it is NOT
suitable for outdoor use.
•
The use of the product and accessories is forbidden to children under 16 years of
age.
•
Ensure that no children play with the appliance or are in the vicinity without super-
vision.
•
Converting or modifying the product compromises product safety.
•
Handle the product with care. It can be damaged by knocks, blows or falling from
even a small height.
•
Do not use the product near gas or water appliances or in a dusty environment.
•
Use the product only in its intended manner. Any use for any other purpose may
damage the product or its surroundings.
•
Tighten the screws, but do not overtighten them. Overtightening (e.g. by using a
cordless screwdriver) can cause damage and impair the secure hold of the product.
•
If necessary, obtain suitable mounting material for your mounting surface.
•
Make sure that the surface has sufficient load-bearing capacity to securely and sa-
fely mount the product and other components securely and permanently.
•
After mounting the product and other components, check that they are sufficiently
strong and safe to operate.
•
Suspended loads must be checked for strength and load-bearing capacity at least
twice a year.
•
Do not load the product with more weight than permitted. Pay attention to the ma-
1