Descargar Imprimir esta página

Celexon MultiCel LuxusLine OMG-1000 Manual De Instrucciones página 13

Soporte de techo para proyector

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 31
ximum permissible carrying weight.
Make sure that the product is loaded as centrally as possible, especially after the
product has been adjusted.
All supply lines and cables must not be subjected to any additional load and must
be laid in such a way that they are not damaged or crushed.
The product may only be combined with projectors. All mounting points on the
projector must be firmly connected to the bracket.
The bracket may only be connected to or removed from the projector when it is
disconnected from the power and any other cables.
Projectors with more than 4 fixing points must be installed in such a way that 4
points are selected which distributed over the maximum area of the projector
chassis.
The enclosed screws for mounting the projector should be checked for compatibi-
lity with your unit. If they are too long (may damage the projector) or too short (at
least 5 threads must be able to be screwed in), obtain screws suitable for your unit.
After installation of the bracket and the projector attached to it, the entire suspensi-
on must be checked again for bond strength and tight fit to your supporting struc-
ture before commissioning.
During the installation work, secure the installation site over a wide area. No persons
or other objects or furniture should be below it during the installation work.
Ensure that there is sufficient space at the installation site to guarantee safe instal-
lation.
Do not install the product too close to walls or other objects, Projectors must be
able to be ventilated from the outside.
The installation site must be chosen in such a way that it is accessible at all times
and is not obstructed in order to carry out a regular visual and tensile check of all
components (at least twice a year!).
This bracket is only suitable for mounting on ceilings. With sloping ceilings the slope
of the ceiling must not exceed the possible angle of inclination of the bracket. The
projector mount may only be suspended vertically.
Failure to comply with the above instructions may result in personal injury and da-
mage to the product or equipment connected to it. Incorrect installation or use may
also invalidate the warranty.
If you are unsure about the use of the product, please contact your specialist
personnel, your dealer or celexon directly (Web: www.celexon.co.uk, Mail:
info@celexon.co.uk).
2

Publicidad

loading

Este manual también es adecuado para:

Multicel luxusline omg-1000 bMulticel luxusline omg-1000 sMulticel luxusline omg-1000 w